Absolute power test procedure

Written by Bruce Roberson 97-03


The typical application for this is to measure the emitted light level of an transmitter, or the power going into a receiver.

When doing this, remember that if the transmitter is modulated at 50% duty cycle, the average power reading will be lower than the peak power by 50%, eg 3 dB. It is not recommended to perform power measurements on transmitters modulating slower than about 0.1 Mbaud, or inaccurate readings can result.

The power meter must be rated to measure the peak instantaneous power, or detector saturation may result in low optical power measurements.

Safety precautions must match the possible source power levels. With high power systems, this a significant issue.

  • Turn on the instruments ,and allow to warm up. Clean and inspect the patch leads.
  • Use a matching patch lead to connect the instruments to the device being tested.
  • If testing a laser, use of an APC connector plugged into the power meter will reduce optical reflections, and so generally improve measurement accuracy.
  • A multimode measurement requires a mandrel wrap if measuring source power against specifications. If measuring the actual receiver power on an installed system at the receiver end, do not generally use a mandrel wrap.
  • Set the meter to the correct wavelength, in absolute ( dBm ) mode. It now displays the absolute power level in dBm.

How to calculate dBm

The linear-to-dBm calculation method is:

dBm = 10 log ( P1 / P2 )

where P1 = measured power level ( eg in mWatts )
P2 = reference power level, which is 1 mW

See: Decibel dBm definition (w/calculator)



This application note assists in the following application areas...

About Kingfisher

Kingfisher International are specialist designers and manufacturers of handheld fiber optic test equipment.

Our equipment is used in all phases of fiber optic manufacture, installation and maintenance. Our comprehensive documentation and resources help you get started easily.

Kingfisher Products are Australian made, with a global distribution & support network spanning over 70 countries.

You may print, photocopy and redistribute this document for educational use only, provided that this page is printed as is, without modification. This content may not be used commercially.